Fuel and Combustion

Fuel and Combustion

The Experimental Investigation of Pollutants of NOX and CO in a Non-Premixed Pulse Combustor

Authors
Faculty of Engineering, Department of Mechanical Engineering, Islamic Azad University, Mashhad Branch, Mashhad, Iran
Abstract
Pulse combustors are simplest form of combustor with low cost and operating with different fuels. In this research a non-premixed pulse combustor is constructed and some factors affecting the NOX, CO, flame temperature and frequency of combustion are experimentally investigated. The key variables of the experiments are the inlet mass flow rate of fuel and the tailpipe length. The results show that with decreasing the mass flow rate of fuel, the concentrations of NOX and CO are reduced and reached to its minimum values of 17 and 65 ppm, respectively. This level of NOX emission from pulse combustors is quoted to be generally lower than from conventional burners which reported to be 58-138 ppm. Increasing the tailpipe length causes the concentrations of NOX and CO to be decreased and the frequency of combustion is also decreased. The results are compared with the results of other researchers and are in good agreement.
Keywords

1.     A. A. Putnam, Combustion-Driven Oscillations in Industry, Elsevier, NY, 1971.
2.     B. T. Zinn, “Pulse Combustion: Recent Applications and Research Issues,” Twenty-Fourth Symposium (international) on Combustion, The Combustion Institute, Pittsburgh, PA, 1992, pp. 1297-1305.
3.     B. T. Zinn, Pulse Combustion, The World and I magazine, Washington, DC, 1991, pp. 304-311.
4.     J. M. Corliss, A. A. Putnam, M. J. Murphy, and D. W. Locklin, “NOx Emissions from Several Pulse Combustors,” Presented at the 105th ASME Winter Annual Meeting, New Orleans, La., Paper No. 84-JPGC-APC-2, 1984.
5.     YA. B. Zeldoich, P. YA. Sadovnikov, and D. A. Frankkamenetskii, “Oxidation of Nitrogen in Combustion,” Academy of Sciences of the USSR, Inst. Chem. Phys. Moscow, 1947.
6.     J. O. Keller, and I. Hongo, “Pulse Combustion: The Mechanisms of NOX Production,” Combustion and Flam, 80, 1990, pp. 219-234.
7.     J. O. Keller, T. T. Bramlette, P. K. Barr, and J. Alvarez, “NOX and CO Emissions from a Pulse Combustor Operating in a Lean Premixed Mode,” Presented at the Western States Section, The Combustion Institute, Combustion and Flame, 99, 1994, pp. 460-466.
8.     A. J. Beale, “Aerovalved Pulse Combustion”, PhD Dissertation, Div. of Mechanical Engineering and Energy Studies, Cardiff Univ., Cardiff Wales, UK, 1999.
9.     H. W. Au-Yeung, C. P. Garner, and V. I. Hanby, “An Experimental Study of the Effects of Combustion Frequency and Pressure Amplitude on the NO Emissions from Pulse Combustors,” Journal of the Institute of Energy, 71, No. 489, 1998, pp. 204-208.
10.  H. M. Heravi, “Integrated Physical and Chemical Modeling of Pulse Combustors,” PhD Dissertation, Div. of Mechanical Engineering and Energy Studies, Cardiff, Wales, UK, 2003.
11.  R. J. Kee, F. M. Rupley, and J. A. Miller, ChemkinII: A Fortran Chemical Kinetics Package for the Analysis of Gas Phase Chemical Kinetics, Sandia National Laboratories Report No, SAND 89-8009, 1989.
12.  P. Barham, K. J. A. Hargreaves, H. Ipakchi and W. C. Maskell, “Comparison and Analysis of NOX and CO Emissions from 5 and 15 kw Gas-Fired Pulsed Combustors,” Energy Technology Center, Middlesex University, Bounds Green Road, London N11 2NQ, UK, 1991.
13. م. ملکی و ب. دیبایی­نیا، روش­های اندازه­گیری در مهندسی، چاپ اول، انتشارات جهاد دانشگاهی، دانشگاه صنعتی اصفهان، 1369.
14.  J. E. Dec, J. O. Keller, and V. S. Arpaci, “Heat Transfer Enhancement in the Oscillating Turbulent Flow of a Pulse Combustor Tailpipe”, Int. J. Heat Mass Transfer, 35, No. 9, 1992, pp. 447-468. 
15.  H. M. Heravi, J. R. Dawson, P. J. Bowman, and N. Syred, “Primary Pollutant Prediction from Integrated Thermofluid-Kinetic Pulse Combustor Models,” Journal of Propulsion and Power, 21, No. 6, 2005, pp. 1092-1097.
16.  L. Rayleigh, “The Explanation of Certain Acoustical Phenomena” Nature, 18, No. 455, July 1878, pp. 319-321.
17.  A. Kilicarslan, and A. Arisoy, “Acoustic Analysis of a Liquefied Petroleum Gas-Fired Pulse Combustor,” Applied Acoustics, 69, 2008, pp. 770-777.