Fuel and Combustion

Fuel and Combustion

Effect of the composition of syngas derived from biomass gasification on performance and emission characteristic of a diesel-syngas RCCI engine

Document Type : Original Article

Authors
Mortaza Yari 1
Navid Kousheshi 2
Ali Saberimehr 3
1 Department of Mechanical Engineering, Faculty of Mechanical Engineering, University of Tabriz
2 Mechanical engineering faculty, Tabriz university
3 Mechanical Engineering, University of Bonab
10.22034/jfnc.2019.102208
Abstract
Syngas, mainly composed of hydrogen and carbon monoxide, is a suitable candidate for RCCI engines. In the present effort, the impact of syngases with different compositions, on the performance and emissions of a RCCI engine, at constant input energy, has been numerically investigated. For this purpose, different gasification processes have been employed to generate three different types of syngases for comparison with the simulated one which contains solely H2 and CO. Using these kinds of syngases compared with simulated one, results in less NOx in expense of more other emissions and less GIE. The ratio of hydrogen mass to the mass of other combustible species has a direct relation with maximum pressure and temperature, gross indicated efficiency (GIE) and NOx and a reverse relation with other pollutants. Syngas type I with a 78% reduction of NOx and a 11.7% reduction of GIE compared to conventional diesel and a 3.6% increase of exergy destruction compared to simulated syngas is the best alternative syngas in all cases.
Keywords
RCCI Engine
Low Temperature Combustion
Pollution
Syngas

Subjects

  1. V. Chintala, K. A. Subramanian, "A comprehensive review on utilization of hydrogen in a compression ignition engine under dual fuel mode," Renew Sustain Energy Rev," 70, 2017, pp. 472–91.
  2. V. Chintala, K. A., "Subramanian CFD analysis on effect of localized in-cylinder temperature on nitric oxide (NO) emission in a compression ignition engine under hydrogen-diesel dual-fuel mode," Energy, 116, 2016, pp. 470–88.
  3. S. L. Kokjohn, R. D. Reitz, "An investigation of charge preparation strategies for controlled PPCI combustion using a variable pressure injection system," Int J Eng Res, 11, 2010, pp. 257–82.
  4. N. R. Walker, F. D. F. Chuahy, R. D. Reitz, "Comparison of diesel pilot ignition (DPI) and reactivity controlled compression ignition (RCCI) in a heavy-duty engine," ASME 2015 Intern. Combust. Engine Div. Fall Tech, San Diego, CA. Conf., American Society of Mechanical Engineers; 2015.
  5. M. Wissink, R. D. Reitz, "Direct dual fuel stratification, a path to combine the benefits of RCCI and PPC," SAE Int J Engines, 8, 2015, pp. 878–89.
  6. S. Kokjohn, R. Hanson, D. Splitter, J. Kaddatz, R. Reitz, "Fuel reactivity controlled compression ignition (RCCI) combustion in light-and heavy-duty engines," SAE Int J Engines, 4, 2011, pp. 360–74.
  7. C. Noehre, M. Andersson, B. Johansson, A.  Hultqvist, "Characterization of partially premixed combustion," SAE Technical Paper, doi:https://doi.org/10.4271/2006-01-3412, 2006.
  8. D. Kim, I. Ekoto, W. F. Colban, P. C. Miles, "In-cylinder CO and UHC imaging in a light-duty diesel engine during PPCI low-temperature combustion," SAE Int J Fuels Lubr, 1, 2009, pp. 933–56.
  9. S. L. Kokjohn, R. D. Reitz, "Investigation of the roles of flame propagation, turbulent mixing, and volumetric heat release in conventional and low temperature diesel combustion," J Eng Gas Turb Power, 133, 2011, pp. 102805–102110.
  10. M. Teimouri, B. Bahri, "Investigating combustion and emissions parameters in an ethanol fuelled low temperature combustion engine," Fuel Combust Sci Res J, 3, 2018, pp. 65–77. (in Persian)
  11. X. Lu, D. Han, Z. Huang, "Fuel design and management for the control of advanced compression-ignition combustion modes," Prog Energy Combust Sci, 37, 2011, pp. 741–83.
  12. H. Zhao, HCCI and CAI engines for the automotive industry, Woodhead Publishing, 2007.
  13. A. Kakaei, "Advanced engines with low temprature combustion, view to the future," Mech Eng J, 92, 2013, pp. 71–81.(in Persian)
  14. M. M.Salahi, 3D simulation of reactivity controlled compression ignition engines, PhD Thesis, Dep Mech Eng, Tehran Univ Tehran, 2016. (in Persian)
  15. R. D. Reitz, R. M. Hanson, D. A. Splitter, S. L. Kokjohn, Engine combustion control via fuel reactivity stratification, Sandia National Lab.(SNL-NM), Albuquerque, NM (United States), 1259647, 2016.
  16. H. Fajri, S. Shamekhi, "Investigating the Effects of Varying the Intake Air Temperature and Pressure on the Performance and Emissions of RCCI Engines," Fuel Combust Sci Res J, 1, 2016, pp. 23–38. (in Persian)
  17. S. L. Kokjohn, R. M. Hanson, D. A. Splitter, R. D. Reitz, "Fuel reactivity controlled compression ignition (RCCI): A pathway to controlled high-efficiency clean combustion," Int J Engine Res, 12, 2011, pp. 209–26.
  18. N. R. Walker, M. L. Wissink, D. A. DelVescovo, R. D. Reitz, "Natural gas for high load dual-fuel reactivity controlled compression ignition in heavy-duty engines," J Energy Resour Technol, 137, 2015, pp. 1–7.
  19. D. E. Nieman, A. B. Dempsey, R. D. Reitz, "Heavy-duty RCCI operation using natural gas and diesel," SAE Int J Engines, 5, 2012, pp. 270–85.
  20. K. Poorghasemi, R. K. Saray, E. Ansari, B. K. Irdmousa, M. Shahbakhti, J. D. Naber, "Effect of diesel injection strategies on natural gas/diesel RCCI combustion characteristics in a light duty diesel engine," Appl Energy, 199, 2017, pp. 430–46.
  21. A. B. Dempsey, B. D. Adhikary, S  Viswanathan, R. D. Reitz, "Reactivity controlled compression ignition using premixed hydrated ethanol and direct injection diesel," J Eng Gas Turbines Power, 134, 82806, 2012, pp. 1-11.
  22. J. Benajes, S. Molina, A. García, J. Monsalve-Serrano, "Effects of direct injection timing and blending ratio on RCCI combustion with different low reactivity fuels," Energy Convers Manag, 99, 2015, pp. 193–209.
  23. B. B. Sahoo, N. Sahoo, U. K. Saha, "Effect of H2: CO ratio in syngas on the performance of a dual fuel diesel engine operation," Appl Therm Eng, 49, 2012, pp. 139–46.
  24. A. S. Bika, L. Franklin, D. Kittelson, "Cycle efficiency and gaseous emissions from a diesel engine assisted with varying proportions of hydrogen and carbon monoxide (synthesis gas)," SAE Technical Paper, doi:https://doi.org/10.4271/2011-01-1194, 2011.
  25. P. Rahnama, A. Paykani, V. Bordbar, R. D. Reitz, "A numerical study of the effects of reformer gas composition on the combustion and emission characteristics of a natural gas/diesel RCCI engine enriched with reformer gas," Fuel, 209, 2017, pp. 742–53.
  26. F. D. F Chuahy, S. Kokjohn, "System and Second Law Analysis of the Effects of Reformed Fuel Composition in “Single” Fuel RCCI Combustion," SAE Int J Engines, 11, 2018, pp. 861–78.
  27. D. F. Chuahy, S. L. Kokjohn, "Effects of reformed fuel composition in “single” fuel reactivity controlled compression ignition combustion," Appl Energy, 208, 2017, pp. 1–11.
  28. Z. Xu, M. Jia, Y. Li, Y. Chang, G. Xu, L. Xu, et al., "Computational optimization of fuel supply, syngas composition, and intake conditions for a syngas/diesel RCCI engine," Fuel, 234, 2018, pp. 120–34.
  29. F. D. F. Chuahy, S. L. Kokjohn, "High efficiency dual-fuel combustion through thermochemical recovery and diesel reforming," Appl Energy, 195, 2017, pp. 503–22.
  30. K. J. Richards, P. K. Senecal, E. Pomraning, CONVERGE (v 2.3. 5). Converg Sci 2015.
  31. R. Reitz, "Modeling atomization processes in high-pressure vaporizing sprays," At Spray Technol, 3, 1987, pp. 309–37.
  32. A. A. Amsden, P. J. O’Rourke, T. D. Butler, KIVA-II: A Computer Program for Chemically Reactive Flows with Sprays, Report no. LA-11560, Los Alamos Natl Lab, 1989.
  33. Z. Han, R. D. Reitz, "Turbulence modeling of internal combustion engines using RNG κ-ε models," Combust Sci Technol, 106, 1995, pp. 267–95.
  34. D. P. Schmidt, C. J. Rutland, "A new droplet collision algorithm," J Comput Phys, 164, 2000, pp. 62–80.
  35. P. K. Senecal, E. Pomraning, K. J. Richards, T. E. Briggs, C. Y. Choi, R. M. McDavid, et al., "Multi-dimensional modeling of direct-injection diesel spray liquid length and flame lift-off length using CFD and parallel detailed chemistry," SAE Trans, 2003, pp. 1331–51.
  36. P. J. O’Rourke, A. A. Amsden, "A spray/wall interaction submodel for the KIVA-3 wall film model," SAE Trans, 109, 2000, pp. 281–98.
  37. S. Ren, S. L. Kokjohn, Z. Wang, H. Liu, B. Wang, J. Wang, "A multi-component wide distillation fuel (covering gasoline, jet fuel and diesel fuel) mechanism for combustion and PAH prediction," Fuel, 208, 2017, pp. 447–68.
  38. J. B. Heywood, Internal combustion engine fundamentals, McGraw-Hill, 2018.
  39. H. Hiroyasu, T. Kadota, "Models for combustion and formation of nitric oxide and soot in direct injection diesel engines," SAE Trans, 85, 1976, pp. 513–26.
  40. A. Kéromnès, W. K. Metcalfe, K. A. Heufer, N. Donohoe, A. K. Das, C. J. Sung, et al., "An experimental and detailed chemical kinetic modeling study of hydrogen and syngas mixture oxidation at elevated pressures," Combust Flame, 160, 2013, pp. 995–1011.
  41. M. Raju, M. Wang, M. Dai, W. Piggott, D.Flowers, "Acceleration of detailed chemical kinetics using multi-zone modeling for CFD in internal combustion engine simulations," SAE Technical Paper, doi:https://doi.org/10.4271/2012-01-0135, 2012.
  42. Y. A. Cengel, M. A. Boles, Thermodynamics, An engineering approch, McGraw-Hill, 2002.
  43. C. R. Ferguson, Internal Combustion Engines; Applied Thermosciences, USA, Willy publication, 1986.
  44. A. Javaheri, V. Esfahanian, A. Salavati-Zadeh, M. Darzi, "Energetic and exergetic analyses of a variable compression ratio spark ignition gas engine," Energy Convers Manag, 88, 2014, pp. 739–48.
  45. Y. Wang, M. Yao, T. Li, W. Zhang, Z. Zheng, "A parametric study for enabling reactivity controlled compression ignition (RCCI) operation in diesel engines at various engine loads," Appl Energy, 175, 2016, pp. 389–402.
  46. R. D. Reitz, "Directions in internal combustion engine research," Combust Flame, 1, 2013, pp. 1–8.
  47. J. Zhang, E. E. S. Lora, L. R. de Mello e Pinto, P. S. P. Corrêa, "Andrade RV, Ratner A. Experimental study on applying biomass-derived syngas in a microturbine," Appl Therm Eng, 146, 2018, pp. 328–37.
  48. M. Costa, N. Massarotti, L. Vanoli, D. Cirillo, M. La Villetta, "Performance analysis of a biomass powered micro-cogeneration system based on gasification and syngas conversion in a reciprocating engine," Energy Convers Manag, 175, 2018, pp. 33–48.
  49. C. D. Rakopoulos, E. G. Giakoumis, "Second-law analyses applied to internal combustion engines operation," Prog Energy Combust Sci, 32, 2006, pp. 2–47.
  50. J. A. Caton, "Combustion phasing for maximum efficiency for conventional and high efficiency engines," Energy Convers Manag, 77, 2014, pp. 564–76.